Craftsman 917.386082 Manuale del Proprietario Scaricare il pdf (Pagina 8)

INSTALL CONTROL BAR

1. Position control bar so flattened

section with hole is on opposite side

of handle as up-stop bracket.

2. Insert one end of control bar into

handle hole on inside of handle.

Carefully push in on opposite end of

control bar and insert into hole on

opposite side of handle.

Control bar

Up-stop bracket

ASSEMBLEENGINEZONECONTROL

CABLE TO UPPER HANDLE

Assemble cable to opposite side of up-

stop bracket.

1. Route cable below crossbar of lower

handle and up to control bar.

2. Hook "Z" bend fitting on inner wire into

hole in control bar.

3. Attach cable fitting to upper handle as

shown.

4. Secure cable to lower handle with

wire tie.

Control Upper

Upstop

zone

control

cable

ASSEMBLE ENGINE ZONE CONTROL

CABLE TO ENGINE

1. Straighten cable and find the end with

the small plastic fitting.

2. Hook the "Z" bend fitting on inner wire

of cable into hole in brake arm of

engine.

3. Align the tapered end of the small

plastic fitting with the hole in the

mounting bracket and push in until

fitting snaps into place.

INSTALL STARTER ROPE

1. Put threaded end of rope guide

through hole in side of upper handle

above lower handle crossbar. Secure

with 1/4-20 Iocknut.

2. Hold control bar against upper handle

and slowly pull engine starter rope out

until rope will slip into loop of rope

guide.

Mounting

bracket

PUSH IN_

Rope

guide

plastic fitting

arm

Engine

starter rope

8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Commenti su questo manuale

Nessun commento